The professional competition of stamping is increasing, and now many stamping factories are facing the constant price reduction from dirty customers. It has become an urgent problem for every stamping factory to reduce the cost of metal stamping parts. So how can a stamping factory effectively and reasonably reduce the cost of metal stamping parts? Today, Xiaobian will make a concrete analysis for us: Select and improve the outstanding stamping process, and draw up and improve the outstanding stamping process before producing metal stamping parts.

As long as the reasonable stamping process can ensure fewer defects and less waste products in the practical production process, the output value of the products can also be greatly improved together. Outstanding stamping die metal stamping parts are produced directly by stamping die, so we must ensure the quality of the die, especially for mass-produced metal stamping parts at that time, the unevenness of the die quality greatly affected the cost of metal stamping parts.

In addition, hardware stamping parts must also reduce the production process of products as much as possible under reasonable circumstances. Choose automation to produce today's metal stamping parts, especially electronic stamping parts with relatively small weight. The largest proportion of the cost is often labor cost. Therefore, it is imperative to popularize stamping automation.

As far as possible, it is necessary to choose successive stamping dies to promote stamping automation. However, even if manual stamping is used, it is necessary to consider choosing a simple continuous die for some products if possible. Rational use of information about products with low requirements can make full use of leftover materials.

For products with high requirements, we should also make full use of information when planning layout to reduce the proportion of waste. Of course, every stamping factory has its own set of ideas and plans to reduce the cost of metal stamping parts. For different products, we should also analyze the specific situation, but after all, we are still working hard in these five aspects.